The Polk Audio PA600.1 is a monoblock amplifier, designed for subwoofer use.

Where to buy

Seller Price Seller Rating
Show more


The Polk Audio PA600.1 is a monoblock amplifier, designed for subwoofer use.  A mid-range model in the PA series, this amplifier can be used with any automotive speakers. For a higher end amplifier, look at the PA1200.1 or the PA1100.5. For a lower end model, try the PA500.4. This model is CEA-2006 Compliant, providing accurate power ratings. The PA600.1 comes with mounting hardware, including rubber isolation grommets and extra fuses. Made of anodized extruded brushed-aluminum, it weighs 12 pounds.  The end caps are made of cast aluminum and are removable and the cover plate design hides all the wiring.  The logo is in solid aluminum and comes with cobalt blue back lighting. An optional LED light bar or cooling fan can be installed. The unit comes with RCA outputs for the front channels to daisy chain to other amplifiers, if necessary. This unit provides up to 1,200 watts x 1 at 1 ohm dynamic power.

  • 14.4 Volts RMS Not Bridged at 1 kHz
    • 4 Ohms = 300 watts x 1
    • 2 Ohms = 400 watts x 1
    • 1 Ohm   = 600 watts x 1
  • Signal to noise is > 98 dbA
  • Input Sensitivity Range is 150 mV to 7.5 Volts
  • Input Impedance > 20k Ohms
  • Overall Frequency Response (-3 dB Points) is 20 Hz to 250 Hz main channel
  • 2 x 30 amp fuse, power and ground reversal, thermal and short, current overdraw and low impedance protection
  • The unit is 12 lbs and is 2 16/25" high x 13 69/100" wide x 10 1/4" deep or 6.71 cm high x 34.77 cm wide x 26.04 cm deep
About Us