Switch to the ON position, and the flash will start charging (the charging indicator is dim). After several seconds, the charging indicator turns red and TT560 is then ready to shoot. For a test flash, simply press the test button. If the red charging indicator lamp flickers, it indicates low battery. In such case, the power will turn off automatically and you need to replace the batteries. After use, turn power switch to OFF position. Power Control: The flash unit has 8 steps of power output control which indicated by 8 pieces of LED lamp for different level. Press "+" and "-" to raise and lower power: 1/128,1/64,1/32,1/16,1/8,1/4,1/2,1/1
- Vertical Rotation Angle: 0~90 degrees, Horizontal Rotation Angle: 0~270 degrees
- Compatible with Canon Digital EOS and Nikon DSLR cameras
- Power Management: Switch to the ON, the flash will start charging (the charging indicator is dim).
- For a test flash, press the test button. After use, press the ON/OFF to OFF to power off.
- Red charging indicator lamp flickers in every 1s; it indicates low battery.
- The flash unit has 8 steps of power output control which indicated by 8 pieces of LED.
In M Mode, you can set TT560 onto your camera hot shoe or speedlite trigger hot shoe to trigger the flash unit. When shooting, adjust the flash power and press the camera shutter, the flash light will flash under the camera synchronous signal.
S1 Mode is applicable for slave flash in order to create many lighting effects. It is respectively applicable for manual flash environment. When the flash is S1 mode, it will fire synchronously when the master flash fires, comparable with the effect by the use of radio trigger. S2 Mode is applicable for slave flash in order to create many lighting effects. It is respectively applicable for TTL flash environment. The flash unit won't flash synchronously with the first flash but the second flash from the master flash.
For protection in continuous flashes, to prevent the flash head from getting too hot and damage, please do not flash over 20 times when in power lever 1/2,1/1. Please cool down the flash unit for at least 10 minutes. The over-temperature protection function will be activated if you continue to flash after 20 times. In this state the charging time will turn to 10-25s. Please cool down the flash unit around 10 minutes and it will turn to normal state.
When the inner circuit is over-heating, which indicates over use of the flash unit, the inner circuit will shut down power automatically. The flash unit will turn to normal state after the inner circuit is cooled down.
Frequently Asked Questions
Can this flash be fired by the Canon 60D internal flash control off camera?
Yes. The 60D uses the Canon E-TTL flash system which fires a pre-flash to test exposure. You can set the TT560 to ignore this pre-flash. You won't get flash metering control via the camera, but it can trigger these flashes off camera. However, my own testing shows this flash only outputs 40% of the claimed power, so be aware of that issue as well.
Does it work with Nikon d3200?
Yes, it works with Nikon D3200
Will this speedlight work for the Canon EOS Rebel T3?
Yes, It works perfectly.
Add New FAQ
- Horizontal Rotation Angle 0~270 degrees
- Vertical Rotation Angle 0~90 degrees